New to snom VoIP phones.  I'm more used to Yealinks.  Was gifted a D735, Connecting it to a Bicom clouded backend.  It works with a few little problems.  To start with, it's in my bedroom, and the display is so bright it keeps me awake.  Is there a way to torn it off after 15 minutes, say?  

   And how can I find it's IP address?  Probably need to web to it to easily change parameters I expect?

profilePicture

Jacques Riopel

$userLabel.Name

Joined: 13.02.2023

2 Comments

  1. Gianmaria Tononi

    Feb 14, 2023

    Hi,

    To find the IP you can use the phone's interface directly, get into Settings->Network->IP Settings→IPv4, and you can access the web interface by using this IP in a browser (the PBX may be configuring http credentials or https access, by default the phone doesn't have any http credentials).

    You can also set a timer to dim the light and the level of the light when dimmed using the two parameters below

    dim_timer

    backlight

    backlight_idle

    If you have more questions this may require some deeper investigation, please raise a private ticket if you are a Snom partner or ask your Snom reseller to do so for you (or contact our sales team to understand how to become a partner https://www.snom.com/en/contact/contact-person/)

    Thank you

    1. Jacques Riopel

      Feb 14, 2023

      Thanks muchly for that.  I'm going to try now to figure out if I can edit the extension on the Bicom/Asterisk backend UAD to send that instruction to the phone whenever it turns on.  For now I started reading the manual and found how I could locally go into settings and at least DIM the display, which is a pretty good start until I master the initialization / provisioning method for the snoms from my backend.  FWIW, I still have some m3s and m9s wireless snoms I use!