Web User Interface

Advanced - Network (Tab) - Ethernet Ports (Section): Net Port

Phone User Interface

N/A

Firmware

N/A

XML Configuration

<eth_net perm="PERMISSIONFLAGS">VALIDVALUE</eth_net>

Description

This setting is used to configure the NET port of the phone's integrated Ethernet switch. The setting value is a comma-separated list of three (or four) items:

<speed>,<pause>,<advertisement>

valid with 10.1.154.x or newer:

<speed>,<pause>,<advertisement>,<energy_saving>

Whereas each item has the following meaning:

<speed> - setting forced Ethernet speed or enabling auto-negotiation.
<pause> - enable Ethernet flow control via PAUSE frame (empty value leaves the feature disabled)
<advertisement> - space-separated list of properties to advertise (empty advertises all supported properties)
<energy_saving> - enable IEEE802.3az power saving mode (empty value disable the feature) (valid with 10.1.154.x or newer!)

For example, the following setting value would auto-negotiate the Ethernet speed, while leaving the pause feature untouched (empty value between the two commas) and advertising that only 1000MBit and 100MBit full duplex can be auto-negotiated:

auto,,auto 1000full 100full

valid with 10.1.154.x or newer:

auto,,auto 1000full 100full,green

The values 1000full and 1000half are only supported by phones with an integrated Gigabit Ethernet switch.

<pause> is not supported for the D120.

Valid Values

A comma-separated list with these three items (<pause> and <advertisement> may be left blank):

valid with 10.1.154.x or newer:

A comma-separated list with these four items (<pause>, <advertisement> and <energy_saving> may be left blank):

<speed>

<pause>

<energy_saving>

valid with 10.1.154.x or newer

Valid Values

auto
10half
10full
100half
100full
1000full

tx_rx_off
tx_on
rx_on
tx_rx_on

auto
10half
10full
100half
100full
1000full

green
off

Default Value

auto